Monthly Archives: December 2015

And then there were legs.

The joint to secure the legs to the base will be a sliding dovetail.  To make the dovetail slot on the base I first routed a stopped 1/2″ wide, 3/4″ deep groove to remove most of the waste to finish … Continue reading →

I’ve shaped out the four legs today.  First I used the bandsaw to cut out the template close to the line for all legs. Then I sanded to the line to get one good leg. I used double stick tape … Continue reading →

Worked on the pedestal tonight, not too shabby.

I’m building an octagonal side table that looks like the following. Here’s how it’s going. I laminated two 8/4 maple boards to make the 4″ thick pedestal leg. Cut it on the tablesaw to be octagonal. Then turned the center … Continue reading →