Monthly Archives: January 2016

Here’s where I’m at with the cabinet as of today.  Upper cabinet is done, a few new tool holders.  I wonder if this is supposed to be just an ever evolving thing.

Next I cut 8 x 3/4″ pieces that were 4″ wide for the octagonal skirt. Then I routed the same edge profile as I did for the top. I used the tablesaw to cut off the strips of moulding one … Continue reading →

Here is the routed profile done on the router table, classical cove and bead.

Now i used the track saw to cut along the layout lines to make the octagon top.

Next I glued up three sections to make the top.